Stage 3 Project Calibration
Project-based ECU/TCU calibration for custom hardware and specific targets.
Stage 3 project calibration is built for major hardware changes such as turbo, injectors, MAF or transmission. Dyno or road validation planning is recommended.
Who Is It For?
- Well-maintained vehicles
- ECU/TCU combinations cleared by technical pre-check
Programming Methods
BenchBoot
Process
- Vehicle and ECU/TCU details are recorded.
- Original software file is backed up.
- Appropriate programming method (OBD, Bench or Boot) is selected.
- Calibration is applied and checksum verified.
- Diagnostic check and pre-delivery function test are performed.
Technical Scope
OBD, Bench or Boot methods are selected based on ECU type. Original file is backed up, checksum verified and post-write diagnostic check performed.
Risks & Limitations
- Manufacturer warranty may be affected.
- Overly aggressive calibration can reduce engine/transmission lifespan.
- Incorrect file or interruption may require ECU recovery.
- Results vary with maintenance, fuel quality and hardware.
Emission system related operations are offered only after evaluating the vehicle's intended use and applicable regulations. Compliance with legal requirements for road-use vehicles is the responsibility of the vehicle owner.
Quote Form
…